Write to a Redis stream

In the example below, data is captured from the source table named invoice and is written to a Redis stream. The connection is an optional parameter that must refer to the corresponding connection name defined in config.yaml. When the data_type parameter is specified for the job, it overrides the system-wide setting target_data_type defined in config.yaml.

When writing to streams, the optional parameter mapping can be used to limit the number of fields sent to a stream in a message and to provide aliases for them. When the mapping parameter is not used, all fields captured in the source will be passed as the message payload.

Note that streams are different from other data structures in that existing messages are never updated or deleted. Any operation in the source will generate a new message with the corresponding operation code (op_code field) that is automatically added to the message payload.

In this case, the results will be a Redis stream with the name based on the key expression (e.g., invoice:events), with an expiration of 100 seconds for the whole stream. If no expire parameter is given, the keys will never expire.

In the following example, only three original fields will be passed in the message payload: InvoiceId (as message_id), BillingCountry (as country), Total (as Total, no alias provided) and op_code, which is implicitly added to all messages sent to streams.

source:
  server_name: chinook
  schema: public
  table: invoice
output:
  - uses: redis.write
    with:
      connection: target
      data_type: stream
      key:
        expression: "`invoice:events`"
        language: jmespath
      mapping:
        - InvoiceId: message_id
        - BillingCountry: country
        - Total
      expire: 100
RATE THIS PAGE
Back to top ↑